Delivery

• Repeater
• Quick Guide

Function

The repeater functions as a radio amplifier for the ZigBee radio network. A ZigBee device, such as a smoke detector, and the Smart Home Gateway or QIVICON Home Base do not necessarily have to be in the direct wireless range. It is sufficient for one or more intelligent repeaters or plugs to be routed between the device and the head office. To enable the Repeater function, the device must be connected to your Smart Home system. No additional adjustments are required.

In addition, the repeater allows you to charge USB devices such as smartphones or tablets via a USB cable. The maximum power is 1.5 A over both ports. The load function is independent of the registry in the smart home system.

Setup

To use this product, you need a Smart Home system that supports ZigBee wireless protocol.

• Put the repeater in an electrical outlet to feed it.
• Follow the instructions in the Connection Wizard to add new devices that you will find in your Smart Home system's application or Web interface.
  If the Connection Wizard is unavailable, do the following:
  1. Put the Smart Home system in connection mode to add new devices.
  2. Press and hold the side function button for about 10 seconds until the red LED illuminates briefly on the top of the plug once.
  3. During the search, the LED will light red once every 10 seconds. If the LED flashes 2 times, Repeater has successfully logged on to your Smart Home system.

To use the Smart Plug in another system or when replacing the gateway or radio device, it is enough to follow the process of adding new devices to your system. Once the installation process has been successfully completed, the repeater will no longer connect to the system in which it was previously registered.

Customer Service

In case of connection problems, we recommend using smart or repeater plugs to extend the scope of the ZigBee wireless network. For more information and to support the product, please visit

http://support.smabit.eu.

Technical data

• Repeater with USB charging function
• Repeater function for other devices in the ZigBee radio network
• Function button with red LED
• Power: 230V ~ 50Hz
• Standby power consumption: 0.4 W off, 0.9 W on
• Operating temperature:-10 °c to + 45 °c
• Humidity: up to 85% non-condensing
• Dimensions: 78 x 52 x 85.8 mm, 48mm from the edge of the socket
• Weight 125 g
• ZigBee Standard Radio HA 1.2, 2.4 GHz

Legal Notices

Hereby, SMaBiT GmbH declares that this unit is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. For details, please access the following URL:
https://compliance.smabit.eu/