Professional Motion Sensor

Item No.: AV2010/22

Infrared motion Sensor for indoors. Suitable for motion detection to control Smart Home devices as well as scenarios.

Delivery

  • Motion Sensor
  • 1x 3V Lithium Battery type CR2 (in device)
  • Quick Guide
  • Installation Accessories

Installation and operation

You can connect the motion sensor to both the flat and corner walls. The screws and nozzles required for this are included. On the back are pre-drilled holes for the wall assembly, as well as on the inclined sides for the corner assembly.


Make sure the motion sensor fully captures the area to be monitored and check the covered area before final assembly. Set the motion sensor as high as possible to ensure optimum room detection. The sensor range is 12 meters at an angle of 110°.

After registering in the intelligent Home system, the motion sensor remains in test mode for 5 minutes: Each detected motion is indicated by flashing to assist in positioning and alignment. Movements are no longer indicated by a light signal to reduce energy consumption.

To facilitate light control and improve battery life, the sensor remains "on the move" for 3 minutes after motion is detected. If no more movement is detected during this period, the sensor will send the "no move" signal to the smart home system 3 minutes after the last movement.

Setup

To use this product, you need a Smart Home system that supports ZigBee wireless protocol.

  • Remove the flap that protects the battery during transport.
  • Follow the instructions in the Connection Wizard to add new devices that you will find in your Smart Home system's application or Web interface.
    If the Connection Wizard is unavailable, do the following:
    1. Put the Smart Home system in connection mode to add new devices.
    2. Press and hold the function button for about 10 seconds until the red LED illuminates briefly once.
    3. During the search, the LED will light red once every 10 seconds. If the LED flashes 2 times, the device has successfully logged on to your Smart Home system.

Reset or re-learn:
To use the sensor in another system or when replacing the gateway or radio device, it is sufficient to follow the process of adding new devices to your system. Once the installation process has been successfully completed, the sensor will no longer connect to the system in which it was previously registered.

Maintenance

Battery

To replace the battery, open the motion sensor and replace the battery with a model of the same type (lithium CR123A 3V). It is not necessary to re-register the sensor.


The device indicates a low battery level:

  • Reporting to the Smart Home system.
  • Activating the Maintenance mode: Each detected movement is signalled with a LED light.

Set Sensor sensitivity
  1. Open: Normal sensitivity (factory setting)
    The sensor requires two motion pulses for activation. This setting avoids false alarms and is especially recommended when controlling a siren.
  2. Closed: High Sensitivity
    The sensor is activated immediately on the first movement impulse. This setting is recommended if the default configuration moves are not always correctly detected.

Customer Service

In case of connection problems, please use SMaBiT smart plugs, repeaters or wall-mount relays in order to increase the range of the ZigBee radio network. For further information and for product support, please consult

http://support.smabit.eu.

Technical data

  • Passive Infrared motion sensor
  • Sensor range 12 meters, impact angle 110 degrees
  • Microprocessor-controlled white light and noise filtering
  • LED button for setting up and displaying the status
  • Power 1 CR123A 3V-Lithium battery
  • 2-years battery life
  • Operating temperature-10 °c to + 50 °c
  • Dimensions 94 x 64 x 42 mm
  • Humidity: up to 85% non-condensing
  • Weight without batteries 90 g
  • ZigBee Standard Radio HA 1.2, 2.4 GHz

Legal Notices


Made in Taiwan.