4-Button Remote control

Item No.: AV2010/23

Compact remote control with 4 freely programmable function buttons and optical transmission confirmation. Suitable for controlling smart home appliances and scenarios.

Delivery

  • Remote control
  • Lithium battery 3V CR2032
  • Quick Guide

Insert and replace the battery

To use the remote control, you will need a lithium battery (CR 2032), which is included. To use or replace the battery, open the battery compartment by turning with a coin or flat-head screwdriver and insert the battery according to the polarity specified. It is not necessary to re-register the remote control after a battery change.

Setup

To use this product, you need a Smart Home system that supports ZigBee wireless protocol.


  1. Please use the batteries as described in the previous section.
  2. Follow the instructions in the Connection Wizard to add new devices that you will find in your Smart Home system's application or Web interface.

    If the Connection Wizard is unavailable, do the following:
    1. Put the Smart Home system in connection mode to add new devices.
    2. Press and hold the • • Pressed for about 10 seconds until the red LED illuminates briefly once.
    3. During the search, the LED will light red once every 10 seconds. If the LED flashes 2 times, the device has successfully logged on to your Smart Home system.

Reset or re-learn:

To use the remote control in another system or when replacing the gateway or radio device, it is sufficient to follow the process of adding new devices to your system. Once the installation process has been successfully completed, the remote control will no longer be connected to the system in which it was previously registered.

Use

The remote control only works if it is within the wireless range of the Smart Home system. If a keystroke is successfully transferred to the Smart Home system, the red LED lights up briefly on the remote control. In case of connection errors, it lights up twice or stays out of two seconds after approximately 2 seconds.


Important note

To assign a function to the buttons, please use the application of your Smart Home system. The device is functioning correctly when the LED lights up 1 time at the touch of a button.

Customer Service

In case of connection problems, please use SMaBiT smart plugs, repeaters or wall-mount relays in order to increase the range of the ZigBee radio network. For further information and for product support, please consult

http://support.smabit.eu.

Technical data

  • Remote control with 4 freely programmable buttons
  • Red LED Optical Transmission Confirmation
  • Power 1 CR2032 Lithium battery 3V
  • Battery life about 11/2 years
  • Operating temperature-10 °c to + 50 °c
  • Humidity: up to 85% non-condensing
  • Dimensions 65 x 38 x 15 mm
  • Weight without batteries 35 g
  • Splash protected Housing (IP 44)
  • ZigBee Standard Radio HA 1.2, 2.4 GHz

Legal Notices


Made in Taiwan.